Tilting the washer without packing foam past a 30-degree angle may make the tub suspension rods come loose, causing the tub to misalign and create a water leak during the fill cycle. Lorem ipsum dolor sit amet, consectetur adipiscing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in culpa qui officia deserunt mollit anim id est laborum.
- Always unbox the washer as close to the install location as possible to avoid damage to the chassis and internal components.
- Do not remove the bottom foam (EPS) and the foam holding the tub (Middle EPS) until the washer is moved to its install location.
- Do not tip the washer past about a 30-degree angle if the packaging has been removed, including open box units and during transport.
